#1 2019-05-15 17:07:23

Sinisa Knezevic
Member
From: Zagreb, Croatia
Registered: 2010-01-12
Posts: 11
Website

Iextreme,amb

Dear,

in my test case for for one wind farm in "Windfarm overview -> Flow conditions" I see that all WTGs have a problem regarding Iextreme,amb.
But in the "Reports for selected site -> Eff. turb. table" in the defined wind speed range, all the Iex,site values are below ETM values.

I assume Iextreme,amb is the same as Iex,site.

Is this perhaps an issue that has not been updated after final release of 61400 Ed.4?

Thank you very much and kind regards,
Sinisa Knezevic

Offline

Board footer

Powered by FluxBB

[ Generated in 0.009 seconds, 11 queries executed - Memory usage: 508.59 KiB (Peak: 510.95 KiB) ]